+420 267 313 996
info@ndtone.comUltrasonic probes
Ultrasonic probes for flaw detectors
-
Direct ultrasonic transducers for flaw detectors
Purpose: Inspection of metal products of simple geometric forms of manual inspection of panels, large forgings, castings. Transducers with small contact surface are designed for inspection of pipes and tanks, testing for exfoliation. Transducers with a large...
-
TR-straight beam transducers
Purpose: Detection of subsurface defects and thickness measurements of thin sheets. Inspection of objects with high attenuation of ultrasound and heavily corroded surface. Inspection of bolts, studs. Transducers with small contact area suitable for testing of...
-
Angle beam transducers for flaw detectors
Purpose: Inspection of welds, including thin-walled objects. Inspection of pipes, pressure vessels, containers, pumps and valves, turbine blades, shafts, wheels.
Ultrasonic probes for thickness gauge
-
Dual element high-temperature probe 5T12
Purpose Intended for testing the thickness of hot metal parts. Used with thickness meter B6-С and B2.
-
Dual element probe 5A10
Purpose Measurement of thickness of walls of metal tanks, containers, pipes of big diameters. Particulars Utilization of new synthetic materials provides low wear and good interfacing with rough surfaces.
-
Dual element probe 10A6
Purpose Measurement of thickness of pipes, curved areas of containers with small radius. Particulars Utilization of new synthetic materials provides low wear and good interfacing with rough surfaces.
-
Dual element probe 2.5A12
Purpose Measurement of residual wall thickness of metallic and non-metallic products during manufacture, operation and repare. Particulars Good acoustic contact on rough and very rusted surface.
-
Small-sized dual element probe 10A4
Purpose Thickness measurement of pipes walls, thin metal plates. Particulars High locality, possibility of testing in hard-to-access locations (longerons, pipes with small diameter, etc).
-
Ultrasonic transducers for GE thickness gauges
Purpose: Residual wall thickness measurement of metal products. Identifies pockets of corrosion of pipes.
-
Ultrasonic transducers for Panametrics thickness gauges
Purpose Residual thickness measurement of metal products. Identifies pockets of corrosion of pipes when working with a thickness gauge 26MG, MG2, MG2XT, MG2DL, 37DL.
Ultrasonic probes for RSWA F2
-
RSWA F2 Transducers
For the RSWA F2 a unique transducer technology has been developed that provides the possibility to replace cables in case of damage. The cable can be replaced by the operator...
-
Pencil Probe
The Pencil Probe for RSWA F2 enables testing even in hard-to-reach places. With its housing diameter of only 16 mm and the length of 100 mm it is designed in...
Single element probes with protective membrane (for Echo-Echo mode)
-
P111-S5C
Purpose Residual wall thickness measurement of metallic and non-metallic products using the gauge in Echo-Echo mode or Multiple-Echo mode, with the ability to measure through and ignore coatings. Particulars Good...
-
P111-S2C
Purpose Residual wall thickness measurement of metallic and non-metallic products for use with the gauge in Echo-Echo mode to read through and ignore coatings. Particulars Good acoustic contact on rough...
Through paint probes
-
Dual element probe 5E10
Purpose Thickness measurement of metal tank walls, containers, large diameter pipes, with the ability to measure through and ignore coatings.
-
Dual element probe 10E6
Purpose Thickness measurement of pipes and curved areas of containers with a small radius, with the ability to measure through and ignore coatings. Particulars Good acoustic contact on rough and...
-
Delay line probe 15DL6
Purpose It’s recommended for thickness measurement of very thin materials. Particulars High locality, possibility of testing in hard-to-access locations (longerons, pipes with small diameter, etc).