+420 267 313 996
info@ndtone.comUltrasonic probes
-
RSWA F2 Transducers
For the RSWA F2 a unique transducer technology has been developed that provides the possibility to replace cables in case of damage. The cable can be replaced by the operator...
-
Pencil Probe
The Pencil Probe for RSWA F-2 enables testing even in hard-to-reach places. With its housing diameter of only 16 mm and the length of 100 mm it is designed in...
-
Direct ultrasonic transducers for flaw detectors
Purpose: Inspection of metal products of simple geometric forms of manual inspection of panels, large forgings, castings. Transducers with small contact surface are designed for inspection of pipes and tanks, testing for exfoliation. Transducers with a large...
-
TR-straight beam transducers
Purpose: Detection of subsurface defects and thickness measurements of thin sheets. Inspection of objects with high attenuation of ultrasound and heavily corroded surface. Inspection of bolts, studs. Transducers with small contact area suitable for testing of...
-
Dual element high-temperature probe 5T12
Purpose Intended for testing the thickness of hot metal parts. Used with thickness meter B6-С and B2.
-
Dual element probe 5A10
Purpose Measurement of thickness of walls of metal tanks, containers, pipes of big diameters. Particulars Utilization of new synthetic materials provides low wear and good interfacing with rough surfaces.
-
Dual element probe 10A6
Purpose Measurement of thickness of pipes, curved areas of containers with small radius. Particulars Utilization of new synthetic materials provides low wear and good interfacing with rough surfaces.
-
Dual element probe 2.5A12
Purpose Measurement of residual wall thickness of metallic and non-metallic products during manufacture, operation and repare. Particulars Good acoustic contact on rough and very rusted surface.
-
Small-sized dual element probe 10A4
Purpose Measurement of wall thickness of pipes, thin metal plates. Particulars High locality, possibility of testing in hard-to-access locations (longerons, pipes with small diameter, etc).
-
Dual element probe 5E10
Purpose Measuring of thickness of walls of metal tanks, conteiners, pipes of big diameters, also to read through and ignore coatings.
-
Dual element probe 10E6
Purpose Measurement of thickness of pipes, curved areas of containers with small radius, also to read through and ignore coatings. Particulars Good acoustic contact on rough and very rusted surface.
-
Delay line probe 15DL6
Purpose It’s recommends for thickness measurement of very thin materials. Particulars High locality, possibility of testing in hard-to-access locations (longerons, pipes with small diameter, etc).